Additional Level of Safety
The Gas Control Systems from Nereus Alarms provide an additional level of safety. The push button on the control panel is used to control an electrically operated gas shut-off valve (also known as a solenoid valve). In this way the gas can easily be turned on when required and shut off at other times. In the event of a gas alarm the shut-off valve is automatically closed cutting the flow of gas and preventing a dangerous build up. After the alarm condition has cleared the shut-off valve remains closed until it is manually reopened by pushing the button on the control panel. This ensures that gas is not supplied to unlit burners which may still be open. As an extra safety feature, the solenoid valve also needs to be manually reopened (using the push button on the control panel) following a power failure. Please note that solenoid valves are not supplied as part of the Gas Control Systems and need to be purchased separately (Click here to see valves available from Nereus Alarms).
The Need for a Gas Alarm
A leak of LPG (LP Gas) can result from any number of situations such as split or perished flexible hoses, chaffing pipes, leaking joints, poorly installed appliances, cracked cylinder lockers, loose cylinder regulators or unlit burners. Being heavier than air, LPG will sink and collect in the bilge or any available compartment. A naked flame, electrical spark or hot exhaust is all that is required to cause an explosion.
The Usual Problem - Water Damaged Sensors
Traditional LPG sensors mounted in any wet area (eg bilge, cylinder locker, galley) are prone to water damage. Once wet, these sensors are permanently damaged and often give a continuous false alarm. Not knowing whether the alarm is due to a gas leak or damaged sensor, the crew are left unsure how to act. Apart from the inconvenience, this results in an expensive repair and a period without protection.
The Solution - Unique Waterproof Sensor
 To overcome this problem, Nereus Alarms has developed a unique waterproof sensor which is used in their WG range of alarm systems. These remarkable sensors will survive both splashing water and total immersion and are the only ones of their type on the market.
Whether you use your boat for business or pleasure, you will benefit from reliable protection without the trouble or dangers of water damaged sensors.
Other Features
The alarm systems are small, neat and stylish. They are easy to install (either flush or surface mounted), simple to use and require no maintenance. Lights on the control panel indicate power, fault (eg damaged wire to sensor) and alarm conditions. All models have an internal alarm buzzer, an output to drive additional remote sirens and a separate alarm relay output.
Fast Response & Low Power
The latest technology sensors combine fast response and high performance with very low power consumption.
|
Specification
|
|
Model WG300-LLL-V
|
3x LPG gas control system
|
|
LPG alarm sensitivity
|
~10% LEL (lower explosive limit)
|
|
Operating voltage
|
12/24V (10 to 32 Vdc)
|
|
Current consumption
|
180mA (normal operation), 240mA (alarm)
|
|
Temperature range
|
-20°C to +40°C
|
|
Auxiliary buzzer output
|
300mA at supply voltage
|
|
Alarm relay output
|
SPCO, 1A contact rating
|
|
Control panel size
|
96x60x26mm (surface mounted), 96x60x5mm (flush mounted)
|
|
Sensor size
|
35x35x26mm (surface mounted), 35x35x5mm (flush mounted)
|
|
Output drive for gas solenoid valve
|
Up to 2.5A at supply voltage
|
|
|
|
Downloads (pdf) & Links
|
